However, I thought I´d capitalise on my recent experience in the woodworking of my DIY 4x5/6x12 camera. I liked the ultimate handle´s design features and went about making a handle similar to it.
Design demands: A rectangular handle, but should still be ergonomic. Thumb activated shutter release. Attached both to side and bottom of camera. Accessory shoe. Relatively easy to mount and unmount. If possible should still be able to mount camera on tripod with grip attached.
I used a piece of pine, 20mm thick. A piece of sheet aluminium 1mm thick. A flash bracket. A 3/8" to 1/4" tripod adapter. Two 1/4" tripod screws, both male and female at the same time. A couple of smaller bolts. Mahogany stain, black satin paint, and clear gloss lacquer. Glue
And this is the result:
|Side mount and release cable runs through grip, held fast by sculpted piece of black painted aluminium|
|3/4 view. You can see both side and bottom mount (an adapted flash bracket)|
|Side view. 6mm bolt runs through grip into tripod adapter. A 4mm bolt through bottom bracket into handle|
where a nut has been seated and glued
A final addition will be a leather strap stretching from top to bottom towards to the outside, which I can slip my hand through. Makes for easier carrying, and I won´t drop the camera. Did it meet my design criteria? Yes, for the most part. My only gripe is it taking 2 or 3 minutes to attach and remove.